Description
2018 Jeep Renegade 2.4L AT gas ECM / ECU VIN Programmed | Updated
This Engine Control Module (ECM / ECU) is a genuine OEM replacement for all 2018 Jeep Renegade 2.4L AT gas models.
Each unit is VIN-programmed, updated, and fully tested for a true plug-and-play installation with our cloning service.
Built to OEM standards for reliability, calibration accuracy, and long-term performance.
Strict Testing & Quality Assurance
Every ECU is inspected, refreshed, and verified through advanced diagnostic tools. Testing includes:
Complete communication & CAN-bus verification
Sensor input/output and signal integrity checks
Injector & ignition pulse simulation
Power, ground, and load-circuit analysis
Flash memory integrity and checksum validation
Thermal and voltage-stress testing to confirm reliability
Important Note
Some vehicles with IMMO or PATS may require key programming after installation. This is normal.
For a 100% plug-and-play solution with no relearns, your original ECU must be sent in for cloning. We transfer all security data to the replacement unit.
👉Add the cloning service as a bundle at checkout — $300 CAD / $215 USD
A prepaid shipping label will be emailed to you.
If cloning is not selected, the ECU will be VIN programmed, and a key relearn will be required after installation.
Contact Us
Email: info@fixecm.com
Phone: Local: 647-247-8555 | Toll-Free: 1-800-915-5566
Eric Gray –
The ECM arrived quickly and was exactly as described—pre-programmed and ready to install out of the box. Setting it up in my 2018 Jeep Renegade was straightforward, and the vehicle fired right up without any hiccups. It saved me a lot of time compared to reprogramming a used unit, and the support team was helpful when I had a few questions. Overall, a smooth experience from start to finish.
Eric Walker –
The ECU arrived quickly and installed effortlessly—my Jeep runs flawlessly now. Highly recommend for anyone needing a smooth swap!