If your GETRAG transmission control module is damaged, not communicating, or needs to be replaced, cloning is often the easiest solution. By cloning the data from the original unit to a replacement unit, the vehicle can usually be plug and play after installation, with no additional programming needed in many cases.
This service is useful when replacing a TCM, recovering original transmission data, or preparing a compatible replacement module for installation.
Supported GETRAG functions include:
- BMW GETRAG DKG 436 GEN2 Read/Write INT eeprom, Read/Write MAPS
- FORD GETRAG MPS6 GEN3 Read/Write INT eeprom, Read/Write INT flash
- VOLVO GETRAG MPS6 GEN3 Read/Write INT eeprom, Read/Write INT flash
- CHRYSLER GETRAG MPS6 INT flash CS
- DODGE GETRAG MPS6 INT flash CS
- FORD GETRAG MPS6 INT flash CS
- LAND ROVER GETRAG MPS6 INT flash CS
- VOLVO GETRAG MPS6 INT flash CS
- Checksum support
- BENCH mode operation
If you need this service, you can place your order here:
https://fixecm.com/product/tcm-programming-cloning-service-100-plugplay/
