Description
2010 Dodge Caliber 2.4L AT gas ECM / ECU – VIN Programmed | Updated
This Engine Control Module (ECM / ECU) is a genuine OEM replacement for all 2010 Dodge Caliber 2.4L AT gas models.
Each unit is VIN-programmed, updated, and fully tested for a true plug-and-play installation with our cloning service.
Built to OEM standards for reliability, calibration accuracy, and long-term performance.
Strict Testing & Quality Assurance
Every ECU is inspected, refreshed, and verified through advanced diagnostic tools. Testing includes:
Complete communication & CAN-bus verification
Sensor input/output and signal integrity checks
Injector & ignition pulse simulation
Power, ground, and load-circuit analysis
Flash memory integrity and checksum validation
Thermal and voltage-stress testing to confirm reliability
Important Note
Some vehicles with IMMO or PATS may require key programming after installation. This is normal.
For a 100% plug-and-play solution with no relearns, your original ECU must be sent in for cloning. We transfer all security data to the replacement unit.
👉Add the cloning service as a bundle at checkout — $300 CAD / $215 USD
A prepaid shipping label will be emailed to you.
If cloning is not selected, the ECU will be VIN programmed, and a key relearn will be required after installation.
Contact Us
Email: info@fixecm.com
Phone: Local: 647-247-8555 | Toll-Free: 1-800-915-5566
Carlos Rivera –
This ECM/ECU was exactly what I needed for my 2010 Dodge Caliber. It arrived quickly and came VIN programmed, which saved me a lot of time and hassle. Installation was straightforward and truly plug-and-play — no extra coding required. Overall, a reliable part that got my car running smoothly again.
Noah Baker –
The ECM arrived quickly and worked perfectly right out of the box—exactly what my Dodge Caliber needed. Installation was a breeze!
Cooper Wright –
I was nervous about replacing the ECM on my 2010 Dodge Caliber, but this unit made the whole process surprisingly easy. It came already VIN programmed, so I didn’t have to mess with complicated setups or additional tuning. Installation was truly plug and play—I just swapped it in and my car fired right up without any issues. Shipping was faster than I expected, and when I had a quick question, their tech support was knowledgeable and friendly. Overall, a hassle-free experience that saved me both time and money.
Hunter Campbell –
I was a bit nervous about swapping out the ECM on my 2010 Dodge Caliber, but this VIN programmed unit made the process so much easier than I expected. It arrived quickly, and everything fit perfectly without any extra modifications. After installation, the car fired right up with no issues, and all the electronics have been running smoothly ever since. The fact that it was pre-programmed saved me a ton of time and hassle. Overall, this was exactly what I needed to get my Caliber back on the road without any headaches. Highly recommend for anyone facing the same repair!