Description
2010 BMW 1 Series 3.0L ECM / ECU – VIN Programmed | Updated
This Engine Control Module (ECM / ECU) is a genuine OEM replacement for all 2010 BMW 1 Series 3.0L models.
Each unit is VIN-programmed, updated, and fully tested for a true plug-and-play installation with our cloning service.
Built to OEM standards for reliability, calibration accuracy, and long-term performance.
Strict Testing & Quality Assurance
Every ECU is inspected, refreshed, and verified through advanced diagnostic tools. Testing includes:
Complete communication & CAN-bus verification
Sensor input/output and signal integrity checks
Injector & ignition pulse simulation
Power, ground, and load-circuit analysis
Flash memory integrity and checksum validation
Thermal and voltage-stress testing to confirm reliability
Important Note
Some vehicles with IMMO or PATS may require key programming after installation. This is normal.
For a 100% plug-and-play solution with no relearns, your original ECU must be sent in for cloning. We transfer all security data to the replacement unit.
👉Add the cloning service as a bundle at checkout — $200 CAD / $140 USD
A prepaid shipping label will be emailed to you.
If cloning is not selected, the ECU will be VIN programmed, and a key relearn will be required after installation.
Contact Us
Email: info@fixecm.com
Phone: Local: 647-247-8555 | Toll-Free: 1-800-915-5566
Miguel Reynolds –
The ECU arrived super fast with free shipping and was fully programmed for my BMW—installed and running perfectly right away.
Jorge Lewis –
Installed this ECM in minutes with zero hassle—car runs perfectly now. Super fast delivery and spot-on programming!